Pinewood Derby Car Body – 3D Print Body Corvette

$15.95

Pinewood Derby Body – 3D printed Corvette Body

This 3D printed body will be applied to YOUR wood block. Predrill your axle slots / holes. Cut your wood block to 1/4″ in width. Sand smooth and our 3d printed pinewood derby body will fit right on. That’s it for wood work. Mark your wood for some additional sanding contouring to make a custom proper fit to the body,

Car body will be within parameters of the official BSA instructions that come in the box. Some designs will run the block in reverse configuration. These will be noted.

  • Wheelbase is Standard BSA wheelbase
  • 7″ in length, 2.5″ in width
  • Car body weighs approx. 1.75oz in weight
  • Additional weight will be required to bring your car to proper racing weight
  • Buyer must finish
  • wood block, wheels, axles NOT INCLUDED unless otherwise stated

This is simply a body kit.  The pine block must be incorporated.

Wood

Camber rear Wheels

Would you like the Rears Drilled at 3 degrees if ordering wood?

[widget id="block_widget-4"]

Copyright © 2012-2021 Machine Envy, LLC.  All Rights Reserved.  Derby Dust® is a registered trademark of Machine Envy, LLC.

Machine Envy, LLC is neither affiliated with nor endorsed by the Boy Scouts of America. Pinewood Derby® is a registered trademark of Boy Scouts of America.

Derby Worx® is a registered trade mark of Derby Worx, Inc. Rail Rider™ is a registered trademark of Derby Worx, Inc.

Awana® is a Registered Trademark of Awana Clubs International. Machine Envy, LLC is neither affiliated with nor endorsed by the Awana Clubs International.