Pinewood Derby Car Body ONLY —Low Rider

$13.95

Fast Pinewood car body! BSA – compliant complete pinewood derby car. Before your purchase, please check your local rules. If you are unsure about the terminology, just email us, we will get you what you need. See what makes our cars different! 9 different reasons. All Kits are 7 inches in length. All kits are 1.75 inches in width. All kits have a minimum ground clearance of 3/8 inches. All kits are under 1.25 inches in height unless stated otherwise.

What makes our cars different than everyone else? Our car bodies come with those speed tips that everyone says to use and leaves it up to you to figure it out. Finally a car that will compete against the derby dads! Our car bodies come with the speed tips and secrets that everyone charges you to buy their info. With our kit, and a little work on your end, you can dominate your race!

 

WEIGHT INCLUDED.  LEAD CANOPY INCLUDED WITH PURCHASE.  I DO NOT HAVE THIS DESIGN WITH LUG HOLE FOR TUNGSTEN CANOPY.

In stock

Wheel Base *

Important Decision. Check your rules!

Rear Camber

Would you like your rear axles drilled at 3 degrees

Weighted Body *

Do you want your body weighted?

[widget id="block_widget-4"]

Copyright © 2012-2021 Machine Envy, LLC.  All Rights Reserved.  Derby Dust® is a registered trademark of Machine Envy, LLC.

Machine Envy, LLC is neither affiliated with nor endorsed by the Boy Scouts of America. Pinewood Derby® is a registered trademark of Boy Scouts of America.

Derby Worx® is a registered trade mark of Derby Worx, Inc. Rail Rider™ is a registered trademark of Derby Worx, Inc.

Awana® is a Registered Trademark of Awana Clubs International. Machine Envy, LLC is neither affiliated with nor endorsed by the Awana Clubs International.